What needs to be included on the Label

When fragrance oils are used at different percentage loads, they will trigger different information that is required to be present on your CLP labels. Only if triggered, it must contain all or some of the below:

  • Supplier Identification – This is always needed and must include the business name, contact number and your registered business address.
  • Product Identifier – This is also always needed and is the name of your product. This will enable you and the customer to easily identify it (normally based around the scent of the candle).
  • EH208 Information (Ingredients) – This is the allergen information which may trigger your H and in turn the P phrases that need to be supplied. Unless it is necessary to do so regulations state that no more than four chemicals need to be included on the label, only including additional chemicals if the fragrance oil triggers more severe hazards.
  • Hazard (H) Phrases – These are triggered by the ingredients of the fragrance oil when they reach a set percentage, therefore you will find a H phrase present at a 10% load but not at a 5% because less is present. H phrases are used to inform the end user of any hazards present within the product.
  • Precautionary (P) Phrases – Each H phrase will correlate to a P phrase; the P phrase is for the customer and to advise how to minimise any risks that can be caused by the hazards present.
  • Hazard Pictograms – Each pictogram is a warning picture associated to a H phrase. Not all H phrases will trigger a pictogram, again it is based on the percentage of the chemical present that requires the H phrase. The pictograms must be a diamond shape and include a black picture on a white background with a red frame around it, it must be a minimum of 1 cm squared in size. There are 9 CLP Pictograms please follow the link to get more in depth information on these.
  • Signal Word – This will either be ‘Warning’ or ‘Danger’ and the one you use depends on what H phrases are present. You may not need a signal word if it is not triggered.

CLP Label examples

Sometimes, seeing is more beneficial then reading so please find 2 examples below for different fragrances at a 10% load. Both have been broken down to show each section and both reflect different levels of required information.

Minimal CLP information triggered

All CLP information triggered

The size of the label is also crucial, for products of 125 ml or larger need to measure a minimum of 52 x 74 mm in size. If your product is smaller than 125 ml, contrary to popular belief, you do still require a CLP label, however there are different requirements. You can in fact omit either the P and/or H phrases or the pictograms that would normally be required under the CLP.

Candle Safety Information

Burn candles out of the reach of children and pets

Download here

———————————————————————————————————————————————————————————————

Never leave a burning candle unattended.
Do not burn candles on or near anything that can catch fire.
Trim the wick to about 1 cm before lighting.
Always leave 3 cm between burning candles.
Always leave 5 cm between burning candles.
Always leave 10 cm between burning candles.
Do not place candles in a draught.
Do not place candles near a source of heat.
Place candles in an upright position.
Always snuff out the flame. Do not blow it out.
Always use a candle holder.
Keep the wax pool clear of matches and other debris to avoid flaring.
Only use tea light in holders and warming stoves with sufficient ventilation.
Do not move a burning candle.
Use a suitable container as these candles liquefy when burning.
Never use a liquid to extinguish.

This article is intended as a guide only. Whilst we have taken every care to ensure the accuracy of the information is current and up to date, Cosy Owl accepts no liability for any inaccuracies as regulations are amended frequently. Please refer to the Candle Federation for updates.

Find out more about CLP labelling…